Burst pipe: what to do first
Turn off the water at the stopcock first, then call us. We can talk you through the rest while you keep the damage down.
- Call or tap to start
A split pipe can push out a lot of water fast, so the stopcock comes first. Then call, and we will talk you through the rest. Smell gas? Leave the building and call the National Gas Emergency Service before anything else.
What to do right now
Step 1
Turn off the stopcock
It is usually under the kitchen sink. Turn it clockwise until it stops. If it won't move, don't force it with tools.
Step 2
Keep clear of wet electrics
If water is reaching sockets, lights or the fuse box, switch off at the consumer unit, but only if you can reach it from somewhere dry. Stay out from under a bulging ceiling.
Step 3
Drain the pipes down
Turn off the boiler and any immersion heater, then open the cold taps and flush the toilets so the water left in the pipes runs away.
Step 4
Wrap it and catch it
A towel pulled tight round the split slows a weep. Put a bucket underneath and move anything valuable.
Step 5
Take photos
Snap the burst and any damage before you mop up. Your insurer will want them, and you can send them to us too.
Know your valves
- Stopcock: shuts off all the cold water coming into your home. Turn it clockwise until it stops.
- Rising main: the supply pipe from the street, usually coming up through the floor right below the stopcock.
- Isolation valves: on the pipes to each tap. A quarter turn with a flat screwdriver shuts off just that tap.
- Appliance valve: the lever valve for a washing machine or dishwasher. Lever across the pipe means off.
- Drain-off valve: not always fitted, and used to empty the pipes once the stopcock is off. Leave it closed.
- The stopcock only stops cold water coming in, so turn off the boiler or immersion heater for hot water too.
Why pipes burst
- Frost
- Push-fit fittings letting go
- Nail or screw through a pipe
- Old joints
- Corroded old pipe
- High mains pressure
Burst pipes: is it an emergency?
Call us now if:
- Water is still escaping with the stopcock off
- You can’t find the stopcock or it won’t turn
- Water is near the fuse box, lights or sockets
- A ceiling is bulging below the burst
Send the details if: the leak has stopped but you have no water, you have isolated a split at a valve, or an outside tap or garden pipe has burst.
It can wait if: a slow weep at a joint is caught in a bowl and not getting worse, or an old repair is holding but you want it replaced.
What we do when we get there
Step 1
Make it safe
Check the water is properly off, and that the electrics near the leak are safe to touch.
Step 2
Find the damage
Open up enough to see the whole split and the pipe either side, not just the wet bit. We explain what has gone wrong and what the repair involves before we start.
Step 3
Cut out and replace
Replace the damaged section with fittings that suit the pipe you have: copper, plastic or old lead.
Step 4
Test and turn back on
Restore the water slowly, check every joint we touched under pressure, and show you where your stopcock is.
What affects the price
Every burst pipe repair is different, so we don’t quote blind. These are the things that change the job.
- Where the pipe is. Pipes in the open under a sink are quicker than ones under floorboards, inside walls or in boxing.
- What it is made of. Copper and plastic are straightforward. Lead and old iron need special fittings or a longer replacement.
- How much is damaged. Frost often splits a pipe in several places along a run.
- Access and making good. Lifting floors, cutting plasterboard and reaching lofts or tight cupboards all take time.
Burst pipe repair: your questions
I've turned off the stopcock and it's still leaking. Why?
Some water is still sitting in the pipes and the tank. Open the cold taps and flush the toilets to drain it. If it keeps running, the stopcock may not be closing fully, or the burst is on the street side of it. Call us.
Should I turn off the electrics?
Only if water is near sockets, lights or the fuse box and you can reach the consumer unit without standing in water. If it's already wet, keep away and call.
Will my home insurance cover a burst pipe?
Many policies cover escape of water damage, and some cover finding the leak too. Check your policy before booking anyone, and photograph the damage first.
Can you fix a burst lead pipe?
Lead needs different fittings to copper or plastic, and replacing that section is often the better fix. We explain the options before we start. See lead water pipes for more.
How do I stop pipes bursting next winter?
Lag pipes in the loft, garage and along outside walls, keep the heating on low when you're away, and know where your stopcock is. Fix dripping taps too, as a slow drip can freeze in a trap or overflow.
Who fixes it
We tell you what’s yours to fix and what isn’t. Inside your home, the pipe is usually yours to deal with, and we can repair it. The supply pipe from your boundary to the stopcock is the owner’s too. If water is coming up in the pavement or road, outside your boundary, ask Thames Water.
Living in a flat? See leak from the flat above. Council tenants should report it to their landlord: Lewisham, Greenwich or Southwark. For more on repairs, see leak and burst pipe repair.
Related
Where we work
Deptford and the areas around it. Every postcode listed is in our area.
Boundaries: Office for National Statistics (OGL v3.0). Contains OS data © Crown copyright and database right 2024.
- DeptfordSE8
- New CrossSE14
- GreenwichSE10 SE18 SE9 SE3 SE7 SE28 SE2
- LadywellSE13
- LewishamSE13 SE6 SE23 SE26 SE8 SE4 SE14 SE12
- BrockleySE4
- RotherhitheSE16
- PeckhamSE15 SE5
- NunheadSE15
- Hither GreenSE13
- CatfordSE6 SE13 SE4
- LeeSE12
- BermondseySE1
- East DulwichSE22
- WalworthSE17
- CharltonSE7
- Forest HillSE23
- CamberwellSE5
Want it sorted for you?
Tell us what's going on and we'll price the job.
- Call or tap to start